NETGEAR FVS318N-100NAS Requirements for Entering IP Addresses

Introduction

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

Any of the following table buttons might display onscreen:

•Select All. Select all entries in the table.

•Delete. Delete the selected entry or entries from the table.

•Enable. Enable the selected entry or entries in the table.

•Disable. Disable the selected entry or entries in the table.

•Add. Add an entry to the table.

•Edit. Edit the selected entry.

•Up. Move the selected entry up in the table.

•Down. Move the selected entry down in the table.

•Apply. Apply the selected entry.

Almost all screens and sections of screens have an accompanying help screen. To open the

help screen, click the (question mark) icon.

Requirements for Entering IP Addresses

To connect to the wireless VPN firewall, your computer needs to be configured to obtain an IP

address automatically from the wireless VPN firewall, either an IPv4 address through DHCP

or an IPv6 address through DHCPv6, or both.

The fourth octet of an IP address needs to be between 1 and 254 (both inclusive). This

requirement applies to any IP address that you enter on a screen of the web management

interface.

IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by

colons. Any four-digit group of zeroes within an IPv6 address can be reduced to a single zero

or altogether omitted.

The following errors invalidate an IPv6 address:

•More than eight groups of hexadecimal quartets

•More than four hexadecimal characters in a quartet

•More than two colons in a row