Troubleshooting
377
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 225.
b. Click the Default button.
The wireless VPN firewall reboots. During the reboot process, the Settings Backup and
Firmware Upgrade screen might remain visible, or a status message with a counter might
show the number of seconds left until the reboot process is complete. The reboot process
takes about 165 seconds. (If you can see the unit: The reboot process is complete when
the Test LED on the front panel goes off.)
WARNING:
When you press the hardware factory default Reset button or click
the software Default button, the wireless VPN firewall settings are
erased. All firewall rules, VPN policies, LAN and WAN settings,
and other settings are lost. Back up your settings if you intend on
using them.
Note: After you reboot with factory default settings, the wireless VPN
firewall’s password is password, and the LAN IPv4 address is
192.168.1.1.
Address Problems with Date and Time
The System Date & Time screen displays the current date and time of day (see Configure
Date and Time Service on page 333). The wireless VPN firewall uses the Network Time
Protocol (NTP) to obtain the current time from one of several network time servers on the
Internet. Each entry in the log is stamped with the date and time of day.