Routing
243
ProSafe M5300 Switch
3. Use Admin Mode* to select enable or disable. The default value is 'disable.' You can
configure OSPF parameters without enabling OSPF Admin Mode, but they will have no
effect until you enable Admin Mode. The following information will be displayed only if the
Admin Mode is enabled: State, Designated Router, Backup Designated Router, Number of
Link Events, LSA ACK Interval, and Metric Cost. For OSPF to be fully functional, you must
enter a valid IP Address and Subnet Mask via the Interface IP Configuration page or through
the CLI command ip address <ipaddr> <subnet-mask>.
Note: *Once OSPF is initialized on the router, it will remain initialized until
the router is reset.
4. Use Router Priority to enter the OSPF priority for the selected interface. The priority of an
interface is specified as an integer from 0 to 255. The default is 1, which is the highest router
priority. A value of '0' indicates that the router is not eligible to become the designated router
on this network.
5. Use Retransmit Interval to enter the OSPF retransmit interval for the specified interface.
This is the number of seconds between link-state advertisements for adjacencies belonging
to this router interface. This value is also used when retransmitting database descriptions
and link-state request packets. Valid values range from 1 to 3600 seconds (1 hour). The
default is 5 seconds.
6. Use Hello Interval to enter the OSPF hello interval for the specified interface in seconds.
This parameter must be the same for all routers attached to a network. Valid values range
from 1 to 65,535. The default is 10 seconds.
7. Use Dead Interval to enter the OSPF dead interval for the specified interface in seconds.
This specifies how long a router will wait to see a neighbor router's Hello packets before
declaring that the router is down. This parameter must be the same for all routers attached
to a network. This value should a multiple of the Hello Interval, e.g., 4. Valid values range
from 1 to 2147483647. The default is 40.
8. Use Iftransit Delay Interval to enter the OSPF Transit Delay for the specified interface. This
specifies the estimated number of seconds it takes to transmit a link state update packet
over the selected interface. Valid values range from 1 to 3600 seconds (1 hour). The default
value is 1 second.
9. Use MTU Ignore to disable OSPF MTU mismatch detection on received database
description packets. Default value is Disable (MTU mismatch detection is enabled).
10. Use Passive Mode to make an interface passive to prevent OSPF from forming an
adjacency on an interface. OSPF advertises networks attached to passive interfaces as stub
networks. Interfaces are not passive by default.
11. Use Network Type to set the OSPF network type on the interface to broadcast or
point-to-point. OSPF only selects a designated router and originates network LSAs for
broadcast networks. No more than two OSPF routers may be present on a point-to-point
link. The default network type for Ethernet interfaces is broadcast.