New Buck Corporation 20 Room Heater manual Floor Protection, Wall Installation Corner Installation

MINIMUM CLEARANCES

The New Buck Corporation Model 20 must be installed in compliance with the instructions contained in this manual.

CLEARANCE FROM COMBUSTIBLE WALLS AND CEILINGS (Using single wall chimney connector)

The minimum lateral distance between any part of the room heater and combustible walls is shown in Figures 1 and 2.

FIGURE 1 WALL INSTALLATION FIGURE 2 CORNER INSTALLATION

FLOOR PROTECTION

If a freestanding model is to be installed on a combustible floor, a non-combustible pad must be placed below it to protect the floor from burning material from the stove. The pad must be 36” wide by 37” deep. UL tests were conducted without a floor protector. Therefore, the protector can be of any thickness and any K* factor.

The unit must be positioned on the pad so that there is a minimum of 16” from the front of the door opening to the front of the pad, and a minimum of 8” measured horizontally from the sides of the fuel loading and ash removal openings to the sides of the pad.

NOTE: For clearance reductions using wall protectors, refer to the NFPA -211code.