New Buck Corporation 20 Room Heater manual Mounting Trim Panels

		3. Slide the unit out of the fireplace far enough to
		work behind the trim panel reference lines.
		4. Mount the side trim panels. (See Figure 3)
		a. Position the trim panel on the reference line.
		b. Drill mounting holes in center of trim panels
		mounting brackets to allow for adjustment
		in and out if necessary.
		c. Mount the trim panel using the self-tapping
		screws provided.
		5. Place top panel back on reference mark. Take
		top trim panel mounting bracket supplied with
		unit. Position bracket so it overlaps rear lip of
		top trim panel. Drill mounting holes in top of
FIGURE 3	MOUNTING TRIM PANELS	stove using holes in bracket as guide. Tighten
		down screws. NOTE: The mounting Bracket is
		only necessary with direct connect installation.
		6. Now, follow the installation procedures in the
		listed direct connect or positive connect kit you
		are using and install the heater and connect kit in
		the fireplace.
		7. Slide the unit back into the fireplace. Check to be
		sure that the trim panels are properly positioned
		and lie flat against the front of the fireplace. If
		one or more of the panels is out of position, slide
		the unit out and reset by loosening the mounting
		screws and repositioning in the slot.

8.Reinstall the top trim panel by sliding the rear lip of the top trim panel underneath the front lip of the mounting bracket already secured to top of unit.

NOTE: Mount the top trim panel so that it sits in front of the top of the side trim panels.

9.Obtain the brass trim kit provided with unit and slip over the top and sides of trim panels. (Top ends of brass may need to be trimmed to fit.)

10.If direct connect or positive connect kit is not used, follow instructions in steps 1-4c on previous page.

11.Mount top trim panel by drilling mounting holes in center of trim panel mounting brackets, with top end side of top panel overlapping side panel.

12.Using insulation provided, peel and stick to back of panels overlapping fireplace dimensions by 1” on each side and top. (See Figure 3.)

13.Next using high heat silicone or furnace cement run heavy bead of caulking around where panels meet the stove. (See Figure 3.)

14.Slide the unit back into the fireplace. Check to be sure that the trim panels (and brass) are properly positioned and lie flat against the front of the fireplace. If panels are out of position, slide the unit out and reset by loosening the mounting screws and repositioning in the slot. With bar, lift stove in front. Place insulation across front and the surface of hearth or bottom of fireplace, to make complete seal.

15.To check seal of panels, use candle flame and go around the entire area sealed by silicone and insulation. If flame leans toward inside of fireplace, add additional insulation. This ensures an airtight seal.