Nortel Networks 600r manual Rear panel controls and features, Label Description

			Server features 15
Label	Description	Label	Description
C	Critical fault LED	K	System ID LED (white)
D	Major fault LED	J	NIC activity LED (green)
E	Minor fault LED	I	Main power LED (green)
F	Power LED	H	not used
G	Disk 0 Activity/Fault LED (green/amber)

Rear panel controls and features

The following diagram shows the back panel controls and features. On the right is the AC power supply bank. The PCI card bracket is in the middle of the back panel, while the connectors and ports are along the bottom and the left side.

Note: Nortel provides only AC power supply. The server works with a DC-to-AC converter, however, you must ensure converter meets AC requirements as specified on label of power supply cover. To access the power supply cover, remove server cover. For more information about the server cover, see "To remove the server cover" (page 24).

Figure 3

Rear panel

Table 2

Rear panel

Label	Description	Label	Description
A	USB 0, USB 1, USB 2	G	Ground studs (used with system with DC input
	(labelled 0, 1, 2 on the		power supply)
	server)
B	PS/2 Mouse	H	RJ45 NIC 2 Embedded Local Area Network
			(ELAN) connector for the ELAN subnet (engraved
			2 on server)
C	SCSI port	I	RJ45 NIC 1 Customer Local Area Network
			(CLAN) connector for Nortel server subnet
			(engraved 1 on server)

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks