30Chapter 4 Installing the server and peripheral devices

To connect the modem to the server

You require a modem to support remote dial-up access to the CallPilot server. With a modem, Nortel technical support can connect to your CallPilot server for troubleshooting purposes. Nortel connects to your server only when you request technical assistance.

Windows automatically recognizes your modem after you connect it and power it on. The power light (PWR LED) does not illuminate until the Windows device driver successfully loads and recognizes the hardware.

To install the modem, you need the following equipment:

USB modem

RJ-11 analog phone cord

USB cable (supplied with the modem)

an analog line jack

Serial port modems with RS-232 connections are not supported on the 600r.

Step Action

1Connect one end of the USB cable into the modem.

2Connect the other end of the USB cable into USB 2 on the rear panel.

3Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.

4Connect the other end of the telephone cable to the RJ-11 jack in the wall.

—End—

To connect the external SCSI tape drive

When you connect an external SCSI tape drive, the device must be terminated. Your tape drive comes with a terminator. (See Tape drive terminator in Figure 8 "SCSI tape drive with terminator" (page 31).) The 600r server also comes with a server terminator, a VHDCI (Very High Density Connection Interface) Ultra320 SCSI terminator. (See Server terminator in Figure 8 "SCSI tape drive with terminator" (page 31).) In a previous procedure, you are instructed to connect the server terminator to the SCSI port. Before you connect an external tape drive to the 600r, you must remove the server terminator.

Note: If you do not connect a SCSI device to the server, do not remove the server terminator from the SCSI port.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Page 30
Image 30
Nortel Networks 600r manual To connect the modem to the server, To connect the external Scsi tape drive