Ferrite cores secured to an external cable | Nortel Networks 600r

46Chapter 6 EMC emission level protection for the 600r server

Figure 14

Ferrite cores secured to an external cable

Ferrites

Connectors for the

MGate cards

Connector for the

MPB96 board

G101786

The ferrite cores are secured to the appropriate cable with plastic enclosure clips. Tie wraps are added to the cable loop.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 46

Nortel Networks 600r manual Ferrite cores secured to an external cable

Contents

600r Server Hardware Installation Trademarks Japan Denan statement Information for JapanJapan Vcci statement Page May Publication HistoryMarch Publication History Contents Contents Getting help over the phone from a Nortel Solutions Center Chapter How to get helpGetting help from the Nortel Web site Getting help through a Nortel distributor or reseller Conventions for Warnings Chapter 600r server descriptionThis chapter Server features Server dimensions Environmental speciﬁcations Front panel featuresSpecification Environmental condition Power button NMI button not used Reset button ID button Front panel Label Description Rear panel controls and featuresRear panel Label Description PCI riser assembly PCI riser assemblyNetwork connectivity Sample network setup with Meridian Sample network setup MeridianSample network setup Communication Server Sample network setup with Communication Server Switch connectivity LAN connectivity Network requirements Remote access connectivitySupported peripheral devices Supported peripheral devices Device Description Reference documents Installation checklist Chapter Preparing for installationInstallation overview Introduction Global CallPilot Support for Anti-Virus Unpacking the 600r server What is next?To unpack the equipment To remove the server cover Inspecting the interior of serverTo replace the server cover Inspecting the interior of server Preparing for installation Chapter Installing the server and peripheral devices Installing the server To install the server Connecting peripherals to the serverRear panel connectors Rear panel Rear panel connectors Label Description To connect the mouse, keyboard, and monitor to the server To connect the modem to the server To connect the external Scsi tape drive Scsi tape drive with terminator Connecting the server to the Elan subnet Media Access Control address Connecting the server to the Nortel server subnet optionalIf the server Then Installing the Nortel software feature dongle To connect the server to the Nortel server subnet To install the software feature dongle Dongle plugged in to server Dongle without feature key Installing the software feature key Continue with Connecting the server to power Installing the server and peripheral devices Locating the power supply modules Chapter Connecting the server to powerSafety precautions Safety information Rack power and grounding Connecting the server to powerAbout the power supply module Before you begin Connecting the server to power To connect the 600r server to power Example setup of 600r with peripherals What is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Symbols/Numerics Index Index Index Index Page 600r Server Hardware Installation