PCI riser assembly, Network connectivity | Nortel Networks 600r

16Chapter 2 600r server description

Label	Description	Label	Description

D	PCI card bracket	J	Video connector
	(full-height) for MPB96

E	Power supply	K	COM1 DB-9 serial port

F	AC power input	L	PS/2 Keyboard connector

PCI riser assembly

The PCI riser assembly holds the MPB96 voice-processing card. The following diagram shows the PCI riser assembly above the server.

Figure 4

PCI riser assembly

Network connectivity

This section describes how the 600r server can be integrated into your network. The 600r can connect to legacy Meridian 1 (M1) and Communication Server 1000 (CS 1000) systems.

ATTENTION

To secure the CallPilot server from unauthorized access, ensure that the CallPilot network resides behind your network ﬁrewall.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 16

Nortel Networks 600r manual PCI riser assembly, Network connectivity

Contents

600r Server Hardware Installation Trademarks Japan Denan statement Information for JapanJapan Vcci statement Page May Publication HistoryMarch Publication History Contents Contents Getting help over the phone from a Nortel Solutions Center Chapter How to get helpGetting help from the Nortel Web site Getting help through a Nortel distributor or reseller Conventions for Warnings Chapter 600r server descriptionThis chapter Server features Server dimensions Front panel features SpecificationEnvironmental speciﬁcations Environmental condition Power button NMI button not used Reset button ID button Front panel Label Description Rear panel controls and featuresRear panel Label Description PCI riser assembly PCI riser assemblyNetwork connectivity Sample network setup Meridian Sample network setup Communication ServerSample network setup with Meridian Sample network setup with Communication Server Switch connectivity LAN connectivity Remote access connectivity Supported peripheral devicesNetwork requirements Supported peripheral devices Device Description Reference documents Chapter Preparing for installation Installation overviewInstallation checklist Introduction Global CallPilot Support for Anti-Virus Unpacking the 600r server What is next?To unpack the equipment To remove the server cover Inspecting the interior of serverTo replace the server cover Inspecting the interior of server Preparing for installation Chapter Installing the server and peripheral devices Installing the server To install the server Connecting peripherals to the serverRear panel connectors Rear panel Rear panel connectors Label Description To connect the mouse, keyboard, and monitor to the server To connect the modem to the server To connect the external Scsi tape drive Scsi tape drive with terminator Connecting the server to the Elan subnet Media Access Control address Connecting the server to the Nortel server subnet optionalIf the server Then Installing the Nortel software feature dongle To connect the server to the Nortel server subnet To install the software feature dongle Dongle plugged in to server Dongle without feature key Installing the software feature key Continue with Connecting the server to power Installing the server and peripheral devices Chapter Connecting the server to power Safety precautionsLocating the power supply modules Safety information Connecting the server to power About the power supply moduleRack power and grounding Before you begin Connecting the server to power To connect the 600r server to power Example setup of 600r with peripherals What is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Symbols/Numerics Index Index Index Index Page 600r Server Hardware Installation