Preparing for installation | Nortel Networks 600r instruction

26 Chapter 3 Preparing for installation

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.0 14 May 2008

Copyright © 2007-2008, Nortel Networks

Image 26

Nortel Networks 600r manual Preparing for installation

Contents

600r Server Hardware Installation Trademarks Japan Vcci statement Information for JapanJapan Denan statement Page March Publication HistoryMay Publication History Contents Contents Getting help from the Nortel Web site Chapter How to get helpGetting help over the phone from a Nortel Solutions Center Getting help through a Nortel distributor or reseller This chapter Chapter 600r server descriptionConventions for Warnings Server features Server dimensions Environmental speciﬁcations Front panel featuresSpecification Environmental condition Power button NMI button not used Reset button ID button Front panel Rear panel Label Description Rear panel controls and featuresLabel Description Network connectivity PCI riser assemblyPCI riser assembly Sample network setup with Meridian Sample network setup MeridianSample network setup Communication Server Sample network setup with Communication Server Switch connectivity LAN connectivity Network requirements Remote access connectivitySupported peripheral devices Supported peripheral devices Device Description Reference documents Installation checklist Chapter Preparing for installationInstallation overview Introduction Global CallPilot Support for Anti-Virus To unpack the equipment What is next?Unpacking the 600r server To replace the server cover Inspecting the interior of serverTo remove the server cover Inspecting the interior of server Preparing for installation Chapter Installing the server and peripheral devices Installing the server Rear panel connectors Connecting peripherals to the serverTo install the server Rear panel Rear panel connectors Label Description To connect the mouse, keyboard, and monitor to the server To connect the modem to the server To connect the external Scsi tape drive Scsi tape drive with terminator Connecting the server to the Elan subnet If the server Then Connecting the server to the Nortel server subnet optionalMedia Access Control address Installing the Nortel software feature dongle To connect the server to the Nortel server subnet To install the software feature dongle Dongle plugged in to server Dongle without feature key Installing the software feature key Continue with Connecting the server to power Installing the server and peripheral devices Locating the power supply modules Chapter Connecting the server to powerSafety precautions Safety information Rack power and grounding Connecting the server to powerAbout the power supply module Before you begin Connecting the server to power To connect the 600r server to power Example setup of 600r with peripherals What is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Symbols/Numerics Index Index Index Index Page 600r Server Hardware Installation