i2021 ISDN Teleset

Choosing Search returns the next screen, assuming the Directory is empty.

Connecting THE i2021- AUTO-INSTALL

1.Assemble the i2021

NOTE: Make sure the logo plate is installed

2.Verify the PS1/PS2 switch located on the bottom of the Teleset is set correctly. See page 6 for further information on setting the PS1/PS2 switch.

3.Verify the Terminating Resistor (TR) switch is set correctly. See page 6 for further information on setting the TR switch.

4.Connect one end of the eight-pin mounting cord to the ISDN Line- In jack on the bottom of the Teleset. Connect the other end of the cord to the S/T jack on your NT1 or ISDN telephone wall jack.

5.Remove the protective film on the display.

6.Label and install the designation card

AUTO-INSTALL

The i2021 is equipped with an Auto-Install feature. The purpose of Auto- INSTALL is to ensure a complete and painless installation. In this mode, the i2021 will first detect the type of switch the i2021 is connected to, and then will attempt to Auto-SPID. The switch will automatically download the features. The i2021 will then step through each of its programming choices and give you the opportunity to make a selection. After you have made the selection press the “MORE” key to continue.

NOTE: You may abort the Auto-Installby pressing the Menu key at any time

13

Page 19
Image 19
Nortel Networks i2021 Series manual Connecting the i2021- AUTO-INSTALL, Auto-Install