i2021 ISDN Teleset

NOTE: You can abort the T-Wait countdown timer at any time by pressing the Speaker key or any touchtone keypad digit.

The Auto-Installprogramming choices are:

nAdjust Contrast – Select Yes or No.

nSPID – If the switch supports Auto-SPID you will be prompted to choose a SPID. If your switch does not support Auto-SPID, press the “Change” softkey and enter the SPID. After entering the SPID press “Save”.

nThe Teleset will attempt to initialize. If there is a problem the Teleset will prompt you to correct the SPID and/or switch type.

nThe Teleset will download its configuration from the switch. If Parameter Downloading is not available, you will be prompted to program the Teleset manually.

nBacklight – Select On, Off, or Dynamic.

nEnter the Date and Time.

nAdjust the Ring Pattern – Select Yes or No.

nSet the 2nd ring Option – Select Continuous, Partial, or No Ring.

nSet Primary Call Appearances.

nSet Priority Call Appearances.

nSet Terminate Only Call Appearance.

nSet an Intercom Key.

nSet Speed Dial Keys.

nSet the Alarm Clock.

nSet a Password.

NOTE: Auto-Install will only run when the i2021 is in the default mode.

NOTE: To default the i2021 press MENU and enter 91 from the dial keypad. Press the “YES” softkey to complete the default.

WARNING: DEFAULTING THE i2021 WILL ERASE ALL OF THE MEMORY.

AUTO-SWITCH

With Auto-Switch detection, the i2021 determines the type of switch to which you are connected. Should you decide to manually program the switch type, Auto-Switch detect will tell you if a different type of switch is found. You will then be given the opportunity to correct the switch type.

14

Page 20
Image 20
Nortel Networks i2021 Series manual Auto-Switch