Nortel Networks i2021 Series Manual Switch Downloading, Manually Programming Call Appearances

i2021 ISDN Teleset

When the SPID entry is complete, the Teleset must be programmed. The i2021Teleset can download the switch parameters, and/or can be manually programmed.

NOTE: If the SPID is greater than 19 digits, an < will appear to the left of the SPID digits. Use the volume control key to view the entire SPID.

MANUAL SWITCH DOWNLOADING

Switch parameters may be downloaded from the switch to the Teleset over the ISDN line. A download can be requested up to three times in a five- minute period. To download proceed as follows:

1.Press MENU, MORE, MORE, Config, MORE, MORE, and ReqParam/RunSPM (depending on the switch) in order. A message indicates a successful or failed download. If successful, the remainder of the setup parameters need not be entered. These setup characteristics include conference, drop, transfer and Call Appearances. You must enter these parameters manually if the download fails. Press MENU to return to the idle (power-up) screen.

NOTE: If the Teleset detects a DMS-100®or the switch is programmed as a DMS-100®, the ReqParam softkey will be displayed as RunSPM.

NOTE: If the Teleset has not linked with the switch, the display will show “Layer 3 Not Initialized”, “Data Link Down” or “Line Not Ready”.

MANUALLY PROGRAMMING CALL APPEARANCES

Take a look at the layout of the Line and Call Appearance keys. These (16) keys are located on the far-right hand side of the phone. The upper-left-hand

18