System Log
This function allows you to view system events and configure related options. Follow the steps below to enable and view the System Log.
1:Click Configure System Log to continue.
2:Select the system log options (see table below) and click Apply/Save.
Option
Description
Log | Indicates whether the system is currently recording events. You can enable or disable event logging. |
| By default, it is disabled. |
|
|
Log level | Allows you to configure the event level and filter out unwanted events below this level. The events |
| ranging from the highest critical level “Emergency” down to this configured level will be recorded to the |
| log buffer on the Router’s SDRAM. When the log buffer is full, the newest event will wrap up to the top |
| of the log buffer and overwrite the oldest event. By default, the log level is “Debugging”, which is the |
| lowest critical level. The log levels are defined as follows: |
| Emergency is the most serious event level, whereas Debugging is the least important. For instance, |
| if the log level is set to Debugging, all the events from the lowest Debugging level to the most critical |
| level Emergency level will be recorded. If the log level is set to Error, only Error and the level above will |
| be logged. |
|
|
Display | Allows you to select the logged events and displays on the View System Log window for events of this |
Level | level and above to the highest Emergency level. |
|
|
Mode | Allows you to specify whether events should be stored in the local memory, be sent to a remote syslog |
| server, or to both simultaneously. |
| If remote mode is selected, the view system log will not be able to display events saved in the remote |
| syslog server. When either Remote mode or Both mode is configured, the WEB UI will prompt the you |
| to enter the Server IP address and Server UDP port. |
|
|
3:Click View System Log. The results are displayed as follows.
ADSL2+/3G Wireless N300 | ymL15WN |
56 | www.netcomm.com.au |
