24Chapter 4 Installing CallPilot Mini/CallPilot 150
Connecting the CallPilot Mini/CallPilot 150
1Open the CallPilot Mini/CallPilot 150 by inserting a flat screwdriver into the slot on the
Figure 3 shows the inside of the CallPilot housing and points out the cable jacks.
2Connect a TCM cable to Port A and to Port B. Table 5 shows the pin out of Port A and Port B.
Table 5 Port A and Port B Pinouts
Pin number | Port A | Port B |
|
|
|
1 | no connection | no connection |
|
|
|
2 | TCM 3 | TCM 4 |
|
|
|
3 | TCM 1 | TCM 2 |
|
|
|
4 | TCM 1 | TCM 2 |
|
|
|
5 | TCM 3 | TCM 4 |
|
|
|
6 | no connection | no connection |
|
|
|
3Connect the other end of the TCM cables to station ports on your telephone system.
Note: Do not connect the Ethernet cable for your LAN to the Ethernet port until you determine if the CallPilot Mini/CallPilot 150 IP address is compatible with the network. For information about the default CallPilot Mini/CallPilot 150 IP address and how to change the IP address, refer to “Connecting to the CallPilot Mini/CallPilot 150” on page 35.
4Connect the power cable to the CallPilot Mini/CallPilot 150 and the wall socket.
5Run all the cables through the cable trough at the top of the CallPilot Mini/CallPilot 150.
6If you are installing a CallPilot Mini system, attach the EMC Kit around all four of the CallPilot Mini cables. The EMC Kit must be fully closed and attached at the point where the cables exit the CallPilot Mini. Figure 4 shows the EMC Kit and where it is attached.
Note: The EMC Kit must be around the power, Ethernet and two TCM cables in order to achieve Class B Homologations.
If you use cables other than the ones supplied with the CallPilot Mini, make sure all four cables fit inside the EMC Kit and the EMC Kit can be fully closed.
7Close the lid.
