Troubleshooting

 

 

 

 

 

 

 

 

 

 

 

 

 

Message

 

Procedure

 

Reference

 

 

 

page

 

 

 

 

 

 

 

 

 

 

 

 

MemoryCard err Press

 

An error has occurred in writing to or reading from the Memory

 

 

GO

 

Card.

 

 

 

 

 

• Press [Printer] and press S or T to select [GO] and press

 

 

 

 

 

[Enter]. The error is cleared.

 

 

 

Memory card error Insert

 

The Memory Card has been removed during printer setup.

 

 

again.

 

Insert the Memory Card.

 

 

 

 

 

 

 

 

 

 

 

NOTE: When inserting the Memory Card, switch off the main

 

 

 

 

 

power ({).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Insert same memory

 

The machine tried to read data from the Memory Card and did not

 

 

card

 

recognize the Memory Card.

 

 

 

 

 

Insert the Memory Card again.

 

 

 

 

 

 

 

 

 

 

 

NOTE: When inserting the Memory Card, switch off the main

 

 

 

 

 

power ({).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Format error Memory

 

The Memory Card inserted in the machine must be formatted.

 

 

card

 

Format the Memory Card.

 

 

 

 

 

 

 

 

Print overrun Press GO.

Printing has not been performed correctly due to insufficient

 

 

 

 

memory.

 

 

 

 

 

• Press [Printer] to display the following messages.

 

 

 

 

 

- GO: Continues printing. Processed data will be output and

 

 

 

 

 

remaining data will be printed on the next page.

 

 

 

 

 

- CANCEL: Cancels printing.

 

 

 

 

 

- RESET: Resets the printer board. In this case, only the

 

 

 

 

 

printer functions will be reset.

 

 

 

 

 

• Press S or T to select the option required and press [Enter].

 

 

 

 

 

If the Auto Continue setting has been enabled, printing

 

 

 

 

 

automatically resumes after a preset period of time.

 

 

 

 

 

After this error message displays, Page Protect mode is

 

 

 

 

 

automatically enabled.

 

 

 

 

 

 

 

 

Interface occupied

The selected interface is currently being used. Wait for a while

 

 

 

 

and retry.

 

 

 

Checksum Error

The machine has detected an error at startup.

 

 

 

 

Switch off the main power and then switch on again. If the same

 

 

 

 

 

message appears, contact your Service Representative or

 

 

 

 

 

Authorized Service Center.

 

 

BASIC OPERATION GUIDE

6-9

Page 105
Image 105
Olivetti 250MF, 200MF, 16MF user manual Message Procedure