Olympus DM-450 Computer via USB, Boot the PC, Manganese batteries may not be used, This recorder

	Power supply
Notes	Charging by connecting to a
• Manganese batteries may not be used in	computer via USB
this recorder.

•When changing batteries, AAA alkaline batteries or Olympus Ni-MH rechargeable batteries are recommended.

•Be sure to stop the recorder before replacing the batteries. Unloading the batteries while the recorder is in use may corrupt the "le. If you are recording into a "le and the batteries run out, you will lose your currently recorded "le because the "le header will not be able to close. It is crucial to change the batteries once you see only one Hash mark in the battery indicator.

•If it takes longer than 15 minute to replace the dead batteries or if you take the batteries in and out repeatedly at short intervals, you may have to reset the time when you have loaded fresh batteries ( P.20).

•Remove the batteries if you are not going to use the recorder for an extended period of time.

•When playing a voice/music "le, the recorder may be reset due to the reduction of the voltage output of the

batteries depending on the volume level even if [] is displayed in the battery indicator. In this case, lower the volume of the recorder.

•When replacing rechargeable batteries, be sure to use Ni-MH rechargeable batteries. The use of other manufacturers' products can damage the recorder and should be avoided.

You can charge the batteries by connecting to a PC's USB port. When charging, be sure to correctly place the rechargeable batteries (supplied) into the recorder ( P.14).

Do not charge primary batteries such as alkali or lithium batteries. It may cause battery leakage heating and recorder malfunction.

1Boot the PC.

2Connect the USB connection cable to the USB port of the PC.

3In the Stop or Hold status, connect the USB cable to the connecting terminal on the bottom of this recorder while pressing the STOP 4 button.

•[Batt.Charge mode] appears in the display while pressing the STOP 4 button.

•Press and hold the STOP 4 button until [Charging] appears in the display.

1

Power supply

EN

15