Olympus LS-14, LS-12 manual Settings relating to recording

Recording

	Notes
	• Inputting a very loud sound may produce noise
	even when the Mode dial is set to [QUICK] or
	[SMART].
2	• To ensure that you do not lose the beginning of the
	recording, verify that the recording indicator light or
Recording	the mode indicator is lit on the display.
	• When the remaining recording time is less than
	60 seconds, the LED indicator light starts flashing.
	When the remaining recording time drops to 30
	and then 10 seconds, the light flashes faster.
	• While adjusting the recording level manually, the
	sound input may be interrupted.
	• [Folder full] will appear when recording cannot be
	continued. Delete unnecessary files or move them
	to another folder before recording (☞ P.48, P.61).
	• [Memory full] will appear when the memory is
	full. Delete unnecessary files before recording any
	further (☞ P.61).
	• When an SD card is inserted into the recorder,
	be sure to confirm the recording media as either
	[Internal memory] or [SD card] so that there is no
	mistake (☞ P.23, P.72).
	• Processing speed may be slower with some types
	of SD cards. Processing performance may also be
	reduced due to repeated writing and deleting. If
	that happens, reformat the SD card (☞ P.78).
	• We recommend formatting the recording media in
	the recorder before recording.

EN

▌Recording more than 2 GB of data in linear PCM format

Recording will continue even if the volume of a single file exceeds 2 GB in linear PCM format recording.

•The data is saved every 2 GB in separate files. It is treated as multiple files during playback.

•If the 999th file in a folder exceeds 2 GB, recording stops.

▌Settings relating to recording

[Mic Gain] (☞ P.66)	Sets the recording sensitivity.
[Limiter] (☞ P.66)	Switches the correction method
	according to the sound input
	when recording.
[Rec Format] (☞ P.66)	Sets the recording rate for each
	recording format.
	This function can reduce
[Low Cut Filter] (☞ P.67)	noise from air conditions and
	projectors and other similar
	noises.
	Selects whether or not to use
[Plug-in Power] (☞ P.67)	the plug-in power function
	according to the external
	microphone connected to the
	MIC jack.
[Mic Select]* (☞ P.67)	Selects whether or not the
	built-in center microphone is to
	be turned On or Off.
	Pre-recording enables you to
[Pre-Recording] (☞ P.68)	start recording up to 2 seconds
	before you press the button for
	recording.
[Rec Monitor] (☞ P.68)	Selects whether or not to
	output the recording monitor
	sound from the EAR jack.
	You can set the time for
[Smart Time] (☞ P.68)	[SMART] mode automatic
	adjustment.
[Metronome] (☞ P.68)	You can set the metronome as a
	rhythm guide during recording.
* LS-14 only

32