DT Settings | Cisco Systems CF2001P instruction

CF2001P

NEXT

<DT Settings>

1.Click [ID Code] so that it appears in white on a black background.

C4656P008CA

2.Using the keypad in the External Panel Controller, enter the 7-digit ID code.

NOTE

Enter the service representative’s ID code.

C4656P009CA

3.Click [ID Code] again so that it appears in black on a white background.

4.Click [DT Setting].

6.Using the keypad in the External Panel Controller, enter the 4-digit Center ID.

Password: Center ID code; identification number of the Center that the data terminal connects to

C4656P013CA

7.Click [DT-ID] so that it appears in white on a black background.

C4656P014CA

8.Using the keypad in the External Panel Controller, enter the 6-digit data terminal ID.

NOTE

If the number is not 6-digits long, add “0” at the beginning.

DT-ID:	Data terminal ID code; the num-
C4656P015CA	ber of the data terminal
C4656P015CA

C4656P010CA

5.Click [Password] so that it appears in white on a black background.

C4656P012CA

4004-7715-01	– 40 –

Image 41

Cisco Systems CF2001P user manual DT Settings, If the number is not 6-digits long, add 0 at the beginning

Contents

CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the Units Packing material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unit Be sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it may Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer CF2001P Setting Up the Servicing Equipment Setting Up the Converter Setting Up the Selector Tor Connecting the Equipment Cables Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Checking the Date Setting Making System Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameter To set the Sleep Mode parameter Tray Loading Paper Slide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the Options Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the test Checking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada only Transmission Settings Precautions for Connecting a Telephone to the Data Terminal Date/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM If the number is not 6-digits long, add 0 at the beginning DT Settings Setting the Telephone Number Initial Transmission Return