Cisco Systems CF2001P user manual Installing the Oil-Coating Unit, Become damaged

CF2001P

NEXT

12. Separate the top and bottom halves of the empty imaging unit cover.

NOTE

Since the bottom half of the imaging unit cover will be used when the imaging unit is replaced again, store it in a safe place.

Bottom cover

C4004U055AA

13.Carefully swing the release lever back up to its original position, pushing it in until it locks into place.

NOTE

If the release levers are not correctly posi- tioned, the front door cannot be closed.

C4004U056AA

14.Remove the packing materials from the remaining imaging unit slots, and then install the magenta, cyan, and black imaging units in the same way described in steps 2 through 13.

NOTE

Be sure to install the imaging units in their correct slots.

15. After all four imaging units have been installed, grasp the handle of the front door, and then carefully swing the door closed as shown.

■Installing the Oil-Coating Unit

1. Grasp the upper right-side door as shown, and then carefully open the door completely while making sure to support it.

	NOTE
	Be sure to support the upper right-side door
	while carefully opening it; otherwise, it may
	become damaged.
	C4004U173AA
Metal terminals	NOTE
	Do not touch the metal terminals at the front
	of the fusing unit; otherwise, damage may
	occur due to static electricity.

C4004U149AB

C4004U013AA

4004-7715-01 – 6 –