Specifying Who Performs Replacements | Cisco Systems CF2001P

CF2001P

NEXT

■Specifying Who Performs Replacements

NOTE

The message that appears a unit must be replaced can be changed to indicate that either the user or the service representative must perform the replace- ment. Select the appropriate settings depending on the type of servicing being performed.

4.Click [User] or [Service] to select whether each unit should be replaced by the user or the service representative.

C4004PU02CA

1.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

5.Click [END].

6.Click [Menu], and then click [Fin. Time].

C4004P565CA

2. Click [System Input].

C4004P597CA

3. Click [Unit Change].

C4004P584CA

4004-7715-01	– 22 –

Image 23

Cisco Systems CF2001P user manual Specifying Who Performs Replacements

Contents

CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the Units Black imaging unit Clear plastic protective sheet is notPacking material therefore, do not remove Shaded area, is only attached to While carefully opening it otherwise, it may Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots Be sure to support the upper right-side door Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer CF2001P Setting Up the Servicing Equipment Setting Up the Converter Setting Up the Selector Tor Connecting the Equipment Cables Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Checking the Date Setting Making System Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameter To set the Sleep Mode parameter Tray Loading Paper Slide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the Options Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the test Checking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada only Transmission Settings Precautions for Connecting a Telephone to the Data Terminal Date/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM If the number is not 6-digits long, add 0 at the beginning DT Settings Setting the Telephone Number Initial Transmission Return