Rite Caliblation | Cisco Systems CF2001P instruction

CF2001P

NEXT

6.Loosen the screw of the terminal, and then attach the ground wire as shown.

C4004U604AA

7.Attach the upper cover of the converter.

8.Plug the power cable of the converter into an electrical outlet.

9.Plug the power cable of the X-Rite into an electrical outlet.

■X-Rite Caliblation

NOTE

•Start up the External Panel Controller on the Notebook PC before turning on the printer.

•If an error message appears, follow the instructions described in the mes- sage.

•Do not quit the External Panel Controller while it is being used. If it is quit- ted, restart the printer and the External Panel Controller.

1.Start up the External Panel Controller on the Notebook PC.

2.Set the power switch to “I”.

C4004U564AA

3.Make sure that the selector knob is set to “A”.

C4004U598AA

4004-7715-01	– 15 –

Image 16

Cisco Systems CF2001P user manual Rite Caliblation

Contents

CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging Units Clear plastic protective sheet is not Packing material therefore, do not removeShaded area, is only attached to Black imaging unit Installing the Oil-Coating Unit Be sure to install the imaging units in their correct slotsBe sure to support the upper right-side door While carefully opening it otherwise, it may Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper Setting Up the Servicing Equipment CF2001P Setting Up the Converter Setting Up the Selector Connecting the Equipment Cables Tor Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Making System Setting Checking the Date Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered number To set the Sleep Mode parameter Loading Paper Tray Slide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118 Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test Pattern Checking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone Cables Precautions for Connecting a Telephone to the Data Terminal Transmission Settings Date/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginning Setting the Telephone Number Return Initial Transmission