Return, Initial Transmission | Cisco Systems CF2001P specs

CF2001P

RETURN

<Initial Transmission>

•To perform the initial user registration for the data terminal after the initial settings have been specified, connect to the Center so the initial information can be sent to the data terminal.

3.Click the Panel Reset key in the External Panel Controller.

NOTE

Call the Center by telephone before and after the initial transmission for verification. In addition, after the transmission, check that the data (total counters, etc.) has been sent correctly to the Center.

1. Click [Initial Transmission].

4002U103EA

4. Click [Fin. Time].

C4004P566CA

C4656P010CA

2.After the initial transmission is completed, check that “End normal.” appears on the screen.

NOTE

This completes input of the Maintenance Center settings. If the Billing Center settings must be specified, perform it in the same way.

C4656P019CA

C4656P018CA

	Messages


	Line is busy.	Not answering.

	Max. trial number reached.	The other line is busy.

	Connection failed.	DT modem error.

	Connected.	Dialing.

	End normal.	DT Connection failed.

4004-7715-01	– 42 –

Image 43

Cisco Systems CF2001P user manual Return, Initial Transmission

Contents

CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the Units Black imaging unit Clear plastic protective sheet is notPacking material therefore, do not remove Shaded area, is only attached to While carefully opening it otherwise, it may Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots Be sure to support the upper right-side door Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper CF2001P Setting Up the Servicing Equipment Setting Up the Converter Setting Up the Selector Tor Connecting the Equipment Cables Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Checking the Date Setting Making System Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameter To set the Sleep Mode parameter Tray Loading Paper Slide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the Options Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the test Checking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada only Transmission Settings Precautions for Connecting a Telephone to the Data Terminal Date/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT Settings Setting the Telephone Number Initial Transmission Return