Loading Paper, Tray | Cisco Systems CF2001P specs

CF2001P

NEXT

9. Loading Paper

NOTE

For more details about loading paper, refer to the User Manual.

■Tray 1

1. Prepare paper that meets this product’s specifications.

2. Pull out the paper drawer for Tray 1.

C4004U071AA

3.Press down on the paper-lifting plate until it locks into place.

5. Load the paper into the drawer so that the front side of the paper (the side facing up when the package was unwrapped) faces up.

NOTE

• Do not load so much paper that the top of the stack is higher than the mark indicat-

C4004U074AA ing the maximum paper capacity.

•Be careful not to touch the surface of the paper take-up roller with your hands. If the roller has been touched, wipe it with a dry cloth.

6. Slide the adjustable paper guides against the edges of the paper.

NOTE

Check that the adjustable paper guides are pushed up against the edges of the paper.

C4004U072AA	C4004U170AA

4. Slide the adjustable paper guides to fit the size of paper to be loaded.

C4004U073AA

7.Close the paper drawer.

8.Turn the media type selection dial on the drawer to the setting for the type of paper loaded.

9.From the control panel, select the size of the paper loaded into Tray 1.

NOTE

For details on specifying settings, refer to the User Manual.

4004-7715-01	– 27 –

Image 28

Cisco Systems CF2001P user manual Loading Paper, Tray

Contents

CF2001P Outline of the CF2001P System Setup Unpacking Unpacking the AccessoriesUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging Units Clear plastic protective sheet is not Packing material therefore, do not removeShaded area, is only attached to Black imaging unit Installing the Oil-Coating Unit Be sure to install the imaging units in their correct slotsBe sure to support the upper right-side door While carefully opening it otherwise, it may Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affix the label that corresponds with the installed options Connecting the CablesAffixing the Support Label Checking the Operation of the Printer Installing the Manual HolderLoading Test Paper Setting Up the Servicing Equipment CF2001P Setting Up the Converter Setting Up the Selector Connecting the Equipment Cables Tor Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Read the Pattern of Cyan disappears from If the cyan test pattern is read correctlyDialog box Making System Setting Checking the Date Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered number To set the Sleep Mode parameter Loading Paper Tray Slide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118 Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test Pattern Checking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone Cables Precautions for Connecting a Telephone to the Data Terminal Transmission Settings Date/Time Settings Clearing the Maintenance RAM Maintenance Center Billing Center SettingsEnter the service representative’s ID code DT Settings If the number is not 6-digits long, add 0 at the beginning Setting the Telephone Number Return Initial Transmission