CF2001P

NEXT

5. Click [Left Margin].

C4658P003CA

6.Select the key for the third paper drawer, and then click the Start key in the External Panel Controller.

C4659P002CB

Checking and Adjusting the Paper Reference Position for AD-14

NOTE

Perform the procedure below after adjusting the paper reference positions for the paper feed unit and the large-capacity cabinet.

For details on the installing AD-14, refer to its Setup Instructions.

To adjust AD-14, follow the instructions below.

To exit the External Panel Controller, refer to step 14 on page 24.

1.Load A4-size (or Letter size) paper into the paper drawer of the Tray1.

2.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

C4004P565CA

7.Measure the margin from the edge of the paper to the pattern printed in the top-right

 

corner of the test page.

a

Standard width (a):

 

3.0mm ± 1.0 mm (with Fiery X3e installed)

5.0mm ± 1.0 mm (with MicroPress PrintLink 2020m installed)

Click the up and down arrows in the lower- right corner of the screen to enter the differ- ence (in millimeters) between the measured width and the standard width.

C4658U028AA

8.Print another test page and check the paper reference position.

3. Click [Machine Adjust].

C4004P597CA

4. Click [PRT Area].

C4004P588CA

4004-7715-01

– 33 –

 

Page 34
Image 34
Cisco Systems CF2001P user manual Click Left Margin