Click Machine Adjust | Cisco Systems CF2001P specs

CF2001P

NEXT

10.Check that the message displayed in the control panel changes from “Alert Printing suspended” to “Info”.

11.Exit the External Panel Controller.

■Checking and Adjusting the Paper Reference Position for PF-117

NOTE

•For details on the installing PF-117, refer to its Setup Instructions.

•To adjust PF-117, follow the instructions below.

•To exit the External Panel Controller, refer to step 14 on page 24.

1.Load A4-size (or Letter-size) paper into the paper drawer of the large-capacity cabinet.

2.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

C4004P565CA

3. Click [Machine Adjust].

C4004P597CA

4. Click [PRT Area].

C4004P588CA

4004-7715-01	– 32 –

Image 33

Cisco Systems CF2001P user manual Click Machine Adjust

Contents

CF2001P Outline of the CF2001P System Setup Unpacking the Accessories UnpackingUnpacking the Printer Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the Units Packing material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unit Be sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it may Remove the oil-coating unit from its box Filling the Toner C4004U062AA Connecting the Cables Affix the label that corresponds with the installed optionsAffixing the Support Label Installing the Manual Holder Checking the Operation of the PrinterLoading Test Paper CF2001P Setting Up the Servicing Equipment Setting Up the Converter Setting Up the Selector Tor Connecting the Equipment Cables Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori If the cyan test pattern is read correctly Read the Pattern of Cyan disappears fromDialog box Checking the Date Setting Making System Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameter To set the Sleep Mode parameter Tray Loading Paper Slide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the Options Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the test Checking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada only Transmission Settings Precautions for Connecting a Telephone to the Data Terminal Date/Time Settings Maintenance Center Billing Center Settings Clearing the Maintenance RAMEnter the service representative’s ID code If the number is not 6-digits long, add 0 at the beginning DT Settings Setting the Telephone Number Initial Transmission Return