Do not measure from the back of the test | Cisco Systems CF2001P

CF2001P

NEXT

5. Click [Dup. Left Margin].

C4657P001CA

6. Click [1st.].

8.Measure the width of loss for the test pattern printed on the back of the test page.

	a	NOTE
	a	Do not measure from the back of the test
		Do not measure from the back of the test
		pattern.

Standard width (a):

3.0mm ± 1.0 mm (with Fiery X3e installed)

5.0mm ± 1.0 mm (with MicroPress PrintLink 2020m installed)

If the measured width of loss does not meet

C4657U014AA its standard width, click and in the lower-right corner of the screen to adjust the

width. Print another test page and check the printed image.

C4659P002CA

7. Click the Start key in the External Panel Controller.

A test page is printed.

C4004U596CA

9.Adjust the paper reference positions for the 2nd, 3rd and 4th drawers in the same way (by repeating steps 6 through 8).

NOTE

The 4th drawer is only available if two optional paper feed units are installed.

4004-7715-01	– 34 –

Image 35

Cisco Systems CF2001P user manual Do not measure from the back of the test, Pattern

Contents

CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the Units Black imaging unit Clear plastic protective sheet is notPacking material therefore, do not remove Shaded area, is only attached to While carefully opening it otherwise, it may Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots Be sure to support the upper right-side door Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer CF2001P Setting Up the Servicing Equipment Setting Up the Converter Setting Up the Selector Tor Connecting the Equipment Cables Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Checking the Date Setting Making System Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameter To set the Sleep Mode parameter Tray Loading Paper Slide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the Options Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the test Checking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada only Transmission Settings Precautions for Connecting a Telephone to the Data Terminal Date/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM If the number is not 6-digits long, add 0 at the beginning DT Settings Setting the Telephone Number Initial Transmission Return