To set the Energy Save Mode parameter | Cisco Systems CF2001P

CF2001P

NEXT

■To set the “Energy Save Mode” parameter

NOTE

When making settings according to the customer’s requests, refer to the procedure described below.

1.Check that the External Panel Controller appears in the computer screen, and then display the Tech. Rep. Mode screen. (For details about displaying the Tech. Rep. Mode screen, refer to the Service Manual.)

2.Click [Utility].

4. Click [Energy Save Mode.]

C4004P600CA

5.Using the keypad in the External Panel Con- troller, enter the desired number of minutes, and then click [Enter].

NOTE

Select the [C] (Clear) key to erase the entered number.

C4004P058CA

6. Click [Exit].

C4004P565CA

3. Click [User’s Choice].

C4004P599CA

7.Click [Exit].

8.Check that the message displayed in the control panel changes from “Alert Printing suspended” to “Info”.

9.Exit the External Panel Controller.

NOTE

Before connecting or disconnecting the har- nesses of the IR port cable, be sure to turn off the printer and the converter.

4004-7715-01	– 25 –

Image 26

Cisco Systems CF2001P user manual To set the Energy Save Mode parameter, Select the C Clear key to erase the entered number

Contents

CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Units Installing the Imaging Units Shaded area, is only attached to Clear plastic protective sheet is notPacking material therefore, do not remove Black imaging unit Be sure to support the upper right-side door Installing the Oil-Coating UnitBe sure to install the imaging units in their correct slots While carefully opening it otherwise, it may Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer Setting Up the Servicing Equipment CF2001P Setting Up the Converter Setting Up the Selector Connecting the Equipment Cables Tor Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Making System Setting Checking the Date Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing To set the Energy Save Mode parameter Select the C Clear key to erase the entered number To set the Sleep Mode parameter Loading Paper Tray Slide the lateral guides against the edges Paper Adjusting the Options Checking the Paper Reference Position for PF-118 Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Do not measure from the back of the test Pattern Checking the Hole-Punching Positions for FN-107 Setting DT-105 USA and Canada only Connecting the Telephone Cables Precautions for Connecting a Telephone to the Data Terminal Transmission Settings Date/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM DT Settings If the number is not 6-digits long, add 0 at the beginning Setting the Telephone Number Return Initial Transmission