Cisco Systems CF2001P guide

CF2001P

NEXT

■Tray 2

1.Prepare paper that meets this product’s specifications.

2. Pull out the paper drawer for Tray 2.

C4004U076AA

3.Press down on the paper-lifting plate until it locks into place.

C4004U077AA

4. Slide the adjustable paper guides to fit the size of paper to be loaded.

5. Load the paper into the drawer so that the front side of the paper (the side facing up when the package was unwrapped) faces up.

NOTE

• Do not load so much paper that the top of

the stack is higher than the mark indicat-

C4004U079AA ing the maximum paper capacity.

•Be careful not to touch the surface of the paper take-up roller with your hands. If the roller has been touched, wipe it with a dry cloth.

6.Slide the lateral guides against the edges of

the paper.

NOTE

Check that the lateral guides are pushed up against the edges of the paper.

C4004O108AA

7. Close the paper drawer.

C4004U078AA

4004-7715-01	– 28 –

Image 29

Cisco Systems CF2001P user manual Slide the lateral guides against the edges Paper

Contents

CF2001P Outline of the CF2001P System Setup Unpacking the Printer Unpacking the AccessoriesUnpacking Removing the Protective Tape and Packing Materials Installing the Imaging Units Installing the Units Packing material therefore, do not remove Clear plastic protective sheet is notShaded area, is only attached to Black imaging unit Be sure to install the imaging units in their correct slots Installing the Oil-Coating UnitBe sure to support the upper right-side door While carefully opening it otherwise, it may Remove the oil-coating unit from its box Filling the Toner C4004U062AA Affixing the Support Label Connecting the CablesAffix the label that corresponds with the installed options Loading Test Paper Installing the Manual HolderChecking the Operation of the Printer CF2001P Setting Up the Servicing Equipment Setting Up the Converter Setting Up the Selector Tor Connecting the Equipment Cables Rite Caliblation Click X-Rite Calibration in the Tech. Rep. Mode screen Dialog box appears if the auto-cal strip was read correctly Turn the cyan test pattern to its original ori Dialog box If the cyan test pattern is read correctlyRead the Pattern of Cyan disappears from Checking the Date Setting Making System Setting Specifying the Serial Number Specifying Who Performs Replacements Printing the List Click Image Processing Select the C Clear key to erase the entered number To set the Energy Save Mode parameter To set the Sleep Mode parameter Tray Loading Paper Slide the lateral guides against the edges Paper Checking the Paper Reference Position for PF-118 Adjusting the Options Click PRT Area Adjusting the Paper Reference Position for PF-118 Click Machine Adjust Click Left Margin Pattern Do not measure from the back of the test Checking the Hole-Punching Positions for FN-107 Connecting the Telephone Cables Setting DT-105 USA and Canada only Transmission Settings Precautions for Connecting a Telephone to the Data Terminal Date/Time Settings Enter the service representative’s ID code Maintenance Center Billing Center SettingsClearing the Maintenance RAM If the number is not 6-digits long, add 0 at the beginning DT Settings Setting the Telephone Number Initial Transmission Return