OMEGA Model CYD201/CYD208 User’s Manual
1.3.1Identifying ESDS Components
Below are some industry symbols used to label components as ESDS:
1.3.2Handling ESDS Components
Observe all precautions necessary to prevent damage to ESDS components before installation. Bring the device and everything that contacts it to ground potential by providing a conductive surface and discharge paths. At a minimum, observe these precautions:
1.
2.Place unit on a grounded conductive work surface.
3.Ground technician through a conductive wrist strap (or other device) using 1 Mseries resistor to protect operator.
4.Ground any tools, such as soldering equipment, that will contact unit. Contact with operator's hands provides a sufficient ground for tools that are otherwise electrically isolated.
5.Place ESDS devices and assemblies removed from a unit on a conductive work surface or in a conductive container. An operator inserting or removing a device or assembly from a container must maintain contact with a conductive portion of the container. Use only plastic bags approved for storage of ESD material.
6.Do not handle ESDS devices unnecessarily or remove from the packages until actually used or tested.
1.4SAFETY SUMMARY
Observe these general safety precautions during all phases of instrument operation, service, and repair. Failure to comply with these precautions or with specific warnings elsewhere in this manual violates safety standards of design, manufacture, and intended instrument use. OMEGA assumes no liability for Customer failure to comply with these requirements.
Ground The Instrument
To minimize shock hazard, connect instrument chassis and cabinet to an electrical ground. The instrument comes with a
Introduction |
