Omega Vehicle Security 1400 manual Calibration Setup, Range 100 mV

Calibration 6

Introduction ……6-1

Calibration Setup ……6-1

Non-Volatile Storage of Calibration Constants ……6-2

Hardware Protected RAM ……6-2

ScanCal Software Application ……6-3

ScanCal’s Main Window ……6-3

Using ScanCal ……6-3

Interface Parameters

System Inventory

Calibration

Manual Calibration of Main Unit ……6-6

Offset Calibration of Main Unit ……6-6

Gain Calibration of Main Unit ……6-8

Manual Calibration of

Signal Conditioning Cards ……6-10

Offset Calibration of Cards ……6-10

Gain Calibration of Low Volts Cards ……6-12

Gain Calibration of High Volts Card ……6-15

Cold Junction Calibration ……6-17

Calibration Without ScanCal ……6-5

Password ……6-5

Calibration Mode Indicator ……6-5

Command Active Indicators ……6-5

CAUTION

Use approved ESD precautions, including static-free work area and grounded wrist strap, when handling circuit boards and electronic components. Failure to do so could cause equipment damage due to electrostatic discharge.

Introduction

ScanCal is a Window’s based software program that provides step-by-step calibration instructions. If you do not wish to use ScanCal, you can manually calibrate the system according to instructions presented later in this chapter. Note that this chapter has been written for both ChartScan and NetScan devices.

Note: The main unit (ChartScan or NetScan) and signal conditioning cards are calibrated prior to shipment; however, these items require periodic calibration to ensure accuracy is maintained. The industry standard for this calibration is once every year.

Note: Main unit calibration is supported only when operating in the Calibration Mode. A specific set of commands is provided for performing manual calibration.

Calibration Setup

CAUTION

To ensure accurate measurements, calibration must only be performed by authorized personnel.

Failure to comply with this requirement can result in faulty equipment performance and necessitate additional services of an authorized metrology lab.

CAUTION

The VDC Calibrator used must meet the following criteria:

1)	Range: 0	- 100 mV	Resolution: 0.1 µV
2)	Range: 0	- 10 V	Resolution: 10 µV

3)Range: 0 - 1000 V Resolution: 1 mV (for CSN14/HV/S card calibration)

4)Remote sensing terminals. Note that stabilizing capacitors will typically be required at the point of connection to the main unit due to the relatively low bandwidth of high resolution VDC calibrators.

Failure to comply with this requirement can result in faulty equipment performance and necessitate additional services of an authorized metrology lab.

ChartScan User’s Manual, 1-12-99 Calibration 6-1