Omega Vehicle Security 1400 manual # Select Card

API CommandsAppendix A

		C# - Select Card
TYPE	Calibration
EXECUTION	Immediate
SYNTAX	C#card	Select the card from which subsequent QC? and U12 interrogation will
		retrieve information.
		Without optional Relay Card
		Valid options for card are: 0 - Selects the chassis; 1, 2, 3, or 4 - Selects the
		card in corresponding slot of the main unit (with 1 being the bottom slot);
		and 5, 6, 7, or 8 - Selects the corresponding slot on the expansion chassis
		(with slot 5 being the bottom slot of the expansion chassis.
		With optional Relay Card Installed (installs in slot 1)
		Valid options for card are: 0 - Selects the chassis; 1 selects card in slot 2,
		2 selects card in slot 3; and so on, with 7 selecting the card in slot 8; and
		no card 8 available.
DESCRIPTION

Using the Select Card (C#) command, selecting a number from the range 1-8for the parameter card will cause subsequent QC? commands to return the calibration factors of the cards by themselves. To return the calibration factors of the cards as part of the system, select a number from the range 101-108.

EXAMPLE

PRINT#1, “OUTPUT07;C#0X”	‘ Select chassis
PRINT#1, “OUTPUT07;QC?X”	‘ Read chassis calibration factors
PRINT#1, “ENTER07"
INPUT #2, A$
PRINT#1, “OUTPUT07;C#5X”	‘ Select the card #5
PRINT#1, “OUTPUT07;U12X”	‘ Read back the time/date that card #5 was last calibrated
PRINT#1, “ENTER07"
INPUT #2, A$
PRINT#1, “OUTPUT07;C#105X”	‘ Select the card #5 in order to read back the calibration factors
	as part of the system
PRINT#1, “OUTPUT07;QC?X”	‘ Read back the system calibration factors of card #5
PRINT#1, “ENTER07"
INPUT #2, A$

Note: In the above example an expansion chassis is being used, thereby allowing an additional 4 card slots.

Note: Card #5 will typically be located in slot #5; however, if the optional relay card is used, card #5 will be located in slot #6 and signal conditioning card use is limited to 7 cards (instead of 8).

A-26 ChartScan User’s Manual