One for All URC-9964B00 manual Programming Combo Device Control

OFA Kameleon wRF UG rev 3.fm Page 18 Monday, September 13, 2004 11:18 AM

KAMELEON 8-DEVICE REMOTE WITH RF

under the VCR or DVD mode keys. Refer to the Setup Codes for DVD Player/ VCR Combos section. You only need to program one code to control your combo device.

1.Turn on the DVD Player/VCR Combo and insert a DVD.

NOTE: Please read steps 2 through 8 completely before proceeding. Before starting step 2, review the “Setup Codes For DVD Player/VCR Combos” (on page 45). Brands are grouped by VCR codes or DVD codes, and are listed alphabetically in order of most popular ones first. Highlight or write down the devices and the codes you wish to program.

2.Press and hold SETUP until the two bottom IR segments flash twice. The Program Keys appear as SETUP flashes repeatedly.

NOTE: . If the display turns off due to inactivity, the remote control exits programming and return to the last-selected device menu screen. To start programming again, repeat this step. To stop programming at any time, press HOME once to return to the Program Keys screen. Press HOME once more to exit completely.

3.Press DEV SET once.The Device Setup programming screen appears:

4.Press DVD once (or VCR if your combo

device uses a VCR Code). The key will animate.

5. Use the Setup Codes For DVD Player/ VCR Combos (on page 45) to locate the brand name and then use the Number Keys to enter the first code for your device. If performed correctly, the two bottom IR segments flash twice.

NOTE: If the two bottom IR segments displayed one long flash instead, an error has occurred. Try entering the same code again.

6. Aim the remote control at the device and press POWER once. The device should turn off.

18 Programming Combo Device Control