oUser will need to press the 
key to answer a call no matter the handset is on the base cradle or out of the base cradle.
Flash (Recall) Timing
When talking on the phone, pressing 
will send a signal to the telephone network.
The flash timing default is 100ms for Australia (Flash 1). You should not need to change this setting unless you connect the phone to a telephone system in your office.
If you need you can select between the three factory programmed flash timing from this menu.
•Press 
. Use 
to select CALL SETTING.
•Press 
. Use 
to select FLASH TIMING.
•Press 
. Use 
to select from the three durations.
Flash 1 = 100ms (Australia)
Flash 2 = 600ms (New Zealand)
Flash 3 = 1000ms (for some older phone systems)
•Press 
on to confirm the selection.
Adjust Time Display Format
During standby, there will be
When a CID with time is received, the clock will automatically be adjusted with the CID time. When the handset batteries are replaced or handset enters low power mode, the clock will restart from 00:00.
To adjust the time,
•Press 
. Use 
to select DISPLAY.
•Press 
. Use 
to select ADJUST TIME.
•Press 
. The current time will be displayed.
•Enter the new time. Value for hour (two digits before “:”) must be less than 24 and value for minute (two digits after “:”) must be less than 60.
•Press 
to confirm.
Handset Name
Each handset can be programmed with its own name, which will be displayed during standby. You can enter up to 10 alphanumeric characters.
•Press 
. Use 
to select DISPLAY.
•Press 
. Use 
to select HANDSET NAME.
•Press 
. The current handset name will be displayed.
•Use the numeric keys and 
to enter the name for the handset.
•Press 
to confirm the name entered.
Call Timer
The length of the call can be timed and displayed. The timer will start counting once the phone goes off hook. When the call has started for 10 seconds, the call timer in the format of mm:ss (e.g. 00:10) will be displayed on the first line of the display if the call timer is activated. Once the timer reaches 59 minutes and 59 seconds (59:59), the format will change to hh:mm:ss (e.g. 01:00:00). It will keep counting until the call ends. When the call has ended, the call timer will stop counting and keep on displaying for 5 seconds.
34 of 42
