Pacific Research Solutions RI-300e User Manual
Page 52
S-Cmd 20 TONE PANEL CTCSS TONE and DCS CODE DECODE ENABLE
The RI-300 controller comes equipped with 6 independent tone panels for 6 different internal functions. These functions
include: Repeater audio, User commands, S-Commands, Auxiliary output, Telephone and Dial click commands. Each CTCSS
tone and DCS code may be independently enabled or disabled for each tone panel. You can have any number and/or
combination of tones/codes enabled. Once the tones you need are enabled, use the appropriate S-Commands (01, 14, 34, 49
and 72) to enable each tone panel for use. You may choose to set up your tone panels with different tones; one for repeater use
only, another tone for a combination of functions: Repeater, User commands and Telephone use. Yet another tone can be used
for just Repeater and S-Commands. This flexibility allows you to customize the repeater for each user.
The above block diagram shows how the repeat audio is processed through the contr oller. This command sets up the Tone
Panel shown in the diagram. Notice that the Tone Squelch Disable, controlled by S-Command 01, is located after the tone
panel.
SYNTAX: 20 [Tone Panel] [Tone Number] [Mode]
READ BACK: 20 [Tone Panel] [Tone Number]
STORAGE: RAM/EEPROM
PARAMETERS: Tone Panel 0 = All tone panels
Tone Panel 1 = Repeater: T his tone p a nel deco des tones that will allow receiver audio to pass to the
repeater’s transmitter.
Tone Panel 2 = User Command: This tone panel decodes tones that will allow receiver audio to pass to
the User Command decoder.
Tone Panel 3 = System Command: This tone panel decodes tones that will allow receiver audio to pass
to the System Command decoder.
Tone Panel 4 = Auxiliary: This tone panel decodes tones that will allow receiver audio to pass to the
auxiliary buss.
Tone Panel 5 = Telephone: T his tone panel decodes tones that will allow receiver audio to pass to the
telephone. The telephone off hook command is also enabled when this tone panel is
decoding.
Tone Panel 6 = Dial Click: This tone panel decod es tones that will allow receiver audio to pass to the
auxiliary buss.
Tone Number 000 = All tones and codes, 001-154 (See tone table below)
Mode 0 = Disable: Disable or turn off a tone for use in the tone panel.
Mode 1 = Enable: Enable or turn on a tone for use in the tone panel.
DEFAULT: All tone panels = 013 (100.0 Hz tone enabled for all panels)
EXAMPLE: 20 0 000 0 Disable all tones on all panels
20 0 013 1 Enable 100.0 Hz on all tone panels
20 1 025 1 Enable 151.4 Hz for the repeater tone panel