Pacific Research Solutions RI-300e User Manual
Page 36
SET UP CTCSS/DCS DECODE The RI-300 controller is equipped with six independent tone panels for six different internal functions. These tone panels will
be discussed in detail, later in the manual. The RPT-TS (Repeater Tone Panel) LED will show when the controller is decoding
a repeater CTCSS tone or DCS code, even though this current decode is not being used in the c ontroller’s operation. The SYS,
AUX, DTMF, DIAL CLICK and HOOK LEDs will flash at a rate of 4 times per second when these tone panel functions are
also decoding tones. These six tone panels have the following functions;
Tone panel #1: Repeater audio only. (RPT-TS LED)
Use S-Command 01 to enable this panel for use.
Tone panel #2: User commands Control. (Flashing DTMF LED)
This tone panel allows access of user commands.
Use S-Command 14 1 to enable this panel for use.
Tone panel #3: S-Commands and Programming. (Flashing SYSTEM LED)
This tone panel allows access to S-Commands and programming.
Use S-Command 14 2 to enable this panel for use.
Tone panel #4: Auxiliary output audio. (Flashing AUX LED)
Used when connecting two controllers are connected together for linking and remote base operation.
Use S-Command 34 to enable this panel for use.
Tone panel #5: Telephone audio and dial commands. (Flashing HOOK LED)
Used to access, dialing and pass audio to the telephone interconnect.
Use S-Command 72 to enable this panel for use. When setting up the telephone tone panel, include the same
tones/code in the repeater and user command tone panels.
Tone panel #6: Dial Click. (Flashing DIAL CLICK LED)
Used for dial click commands, see S-Command 49 for more information.
The controller comes programmed with 100 Hz CTCSS tone, ready for use in all 6-tone panels. Before the controller will use
this tone for operation, you must enable each of the functions associated with each tone panel.
1. Repeater S-Command 01
2. User Command S-Command 14 1
3. S-Command S-Command 14 2
4. Auxiliary S-Command 34
5. Telephone S-Command 72
6. Dial Click S-Command 49
The following example assumes that
you want to disable 100.0 Hz and
enable 127.3 Hz for all tone panels.
See section 12 S-Command 20 for
more details and your specific tone
number.
You can also use the programming
software to edit this message. Pick
“ToneSquelch” then pick “CTCSS
Decode”. You can adjust any of the
tone panels from this dialog box.
The following shows how to add and delete CTCSS tone from the controller using DTMF over the air.
S-Command Description
1. 123456 Unlock the controller, you are in S-Command mode.
2. 20 0 013 0 S-Command 20, Disable the 100.0 Hz tone for all tone panels.
3. 20 0 020 1 S-Command 20, Enable the 127.3 Hz tone for all tone panels.
4. 01 3 S-Command 01, Set repeater mode for COS + CTCSS/DCS.
5. 14 0 1 S-Command 14, Enable both macro and S-Command tone panels.
6. 72 1 S-Command 72, Enable telephone interconnect for CTCSS/DCS operation.
7. 69 1 S-Command 69, Lock the controller and save changes, you are done.