Pacific Research Solutions RI-300e User Manual
Page 46
S-Cmd 04 REPEATER CARRIER DELAY TIMER This timer keeps the repeater transmitter keyed after the
receiver input has dropped. The repeater carrier delay is set in
tenths of seconds (100 milliseconds) increments.
SYNTAX: 04 [Time]
READ BACK: 04
STORAGE: RAM/EEPROM
PARAMETERS: Time 0 = No carrier delay,
1 to 255 = tenths of seconds
(1/10 Seconds or 100 milli-seconds)
DEFAULT: 30 (3.0 Seconds)
EXAMPLE: 04 055 Set carrier delay to 5.5 seconds
04 10 Set carrier delay to 1.0 second
S-Cmd 05 FORCE PTT ON Keys up and “locks on” the repeater transmitter for the selected number of seconds. This provides a constant repeater
transmitter signal for running tests such as measuring power output or checking signal coverage as you drive around. Onc e the
timer has expired, it will not reset itself. You can clear or reset this timer by entering a zero value for the time.
SYNTAX: 05 [Time]
READ BACK: 05
STORAGE: RAM (Power on reset)
PARAMETERS: Time 0 = Reset timer, 1 to 3600 = Seconds (one hour max)
DEFAULT: 0
EXAMPLE: 05 120 Lock on the repeater transmitter for 120 seconds (2 minutes)
05 300 Lock on the repeater transmitter for 300 seconds (5 minutes)
05 0 Reset this timer
S-Cmd 06 REPEATER TELEMETRY MODE Telemetry is divided into 4 groups: (ID, function complete/error, courtesy tones and everything else). This command sets the
telemetry responses to various modes to allow response to the above groups along with speech and CW select. This command
can be used to turn off the function complete and error messages while keeping the ID or courtesy on.
If mode data is set to 1, the controller will temporarily suspend the function complete message or error message. This
suspension of the message is one time only, and does not affect the previously selected global mode. This feature can be used
to keep a function complete message from occurring during a macro or user command. It is more commonly used during an
automatic command or scheduled co mmand.
SYNTAX: 06 [Mode]
READ BACK: 06
STORAGE: RAM/EEPROM
PARAMETERS: Mode 0 = Everything off: All telemetry is off.
1 = Suppress function acknowledgment one time only.
2 = CW ID only: Only CW Station ID will play. All Speech IDs will not play.
3 = CW and Speech ID only: Only CW and Speech Station ID will play.
4 = CW ID and Function ack. only: Only CW Station ID and Function acknowledgments
will play. All Speech IDs will not play.
5 = CW and Speech ID and Function ack. only: Only CW and Speech Station IDs and
Function acknowledgments will play.
6 = CW Messages only: Only CW type messages will play. All Speech messages will not play.
7 = All messages on: All messages will play. This is the most common default.
DEFAULT: Mode 7 = All On
EXAMPLE: 06 0 Turn off all telemetry responses
06 1 Suppress function acknowledgment one time only