Pacific Research Solutions RI-300e User Manual
Page 50
S-Cmd 15 USER COMMAND DECODE ENABLE
This command is used to turn on or off any one of eight groups of user Command. When you build a user command, you are
asked to identify one of eight groups into which the command is placed. You can then use this command to enable or disable
any one of the eight groups. As an example, all telephone type commands can be placed into group 2 and all other commands
are placed into group 1. When you use the telephone, you can include this S-Command in the telephone user command to turn
off group 1. This means that when the telephone is off-hook, all commands in group 1 are disabled. You could also add a
scheduled function to disable the user telephone commands during the night, for example.
Commands that are placed into group 8 can be accessed directly by the telephone incoming call mode while in mode 6 (S-
Command 71) without using the control password (S-Command 57) and with or without group 8 being enabled.
SYNTAX: 15 [Group] [Mode]
READ BACK: 15 [Group]
STORAGE: RAM/EEPROM
PARAMETERS: Group 0 = All groups
Group 1-8 = Each User Command is assigned a group
Mode 0 = Group disable: Turn off a user command group.
Mode 1 = Group enable: Turn on a user command group.
DEFAULT: Group 1 and 2 = 1 (Enable)
EXAMPLE: 15 0 0 Disable (turn off) all User Commands to all groups
15 1 1 Enable (turn on) User Commands to group 1
S-Cmd 16 DTMF INTER-DIGIT TIME
This command sets the maximum time allowed between DTMF digits in a valid command sequence. If the Inter-digit timer
times out before completing a command, the command will be terminated without execution.
SYNTAX: 16 [Data]
READ BACK: 16
STORAGE: RAM/EEPROM
PARAMETERS: Data 1-99 = Time in Tenths of seconds (1/10 Seconds or 100 ms)
DEFAULT: 35 (3.5 Seconds)
EXAMPLE: 16 50 Sets Inter-digit time to 5.0 Seconds
16 25 Sets Inter-digit time to 2.5 Seconds
S-Cmd 17 DTMF MUTE DELAY TIME
This command sets the time that audio is muted when DTMF tones are decoded. Use S-Command 18 to control the use of
muting for the repeater, auxiliary and telephone audio.
SYNTAX: 17 [Time]
READ BACK: 17
STORAGE: RAM/EEPROM
PARAMETERS: Data 1-99 = Time in Tenths of seconds (1/10 Seconds or 100 ms)
DEFAULT: 25 (2.5 Seconds)
EXAMPLE: 17 50 Set mute time to 5.0 Seconds