Panasonic AG-DTL1 manual 76

RS-232C

$ Time lapse control commands

These commands are not acknowledged while a search control command is being processed.

Data transmitted by PC		Data returned from unit in response	Description of command
	[STX] LBR:m [ETX]	[STX] LBR [ETX]	Sets whether the buzzer is to sound when REC REVIEW
Parameter			reveals that the proper video level was not maintained.
m = N: Buzzer ON
F: Buzzer OFF
	[STX] LBZ:m [ETX]	[STX] LBZ [ETX]	Sets whether the buzzer is to sound during alarm recording
Parameter			and sensor recording.
m = N: Buzzer ON
F: Buzzer OFF
	[STX] LMS:m [ETX]	[STX] LMS [ETX]	Sets the timing at which to switch the video signals which
Parameter			are supplied from the camera and which are to be output
m = 0:	1 second		from the rear panel VIDEO OUT connector.
1:	1.5 seconds
2:	2 seconds
3:	2.5 seconds
4:	3 seconds
5:	4 seconds
6:	5 seconds
7:	10 seconds
	[STX] LDA:m [ETX]	[STX] LDA [ETX]	Sets how the control signals are to be output to the
Parameter			component connected to ALARM OUT on the rear panel
m = C: CONTINUE			terminal section when alarm recording or sensor recording
	Control signals continue to		is performed.
	be output even after
	recording.
A: ALARM REC
	Control signals are output
	only during alarm recording
	and sensor recording.
	[STX] LDF:m [ETX]	[STX] LDF [ETX]	Sets whether field recording or frame recording is to be
Parameter			performed for alarm recording and sensor recording.
m = I:	Field recording
R: Frame recording
	[STX] LDM:m [ETX]	[STX] LDM [ETX]	Sets what recording is to be performed when an alarm
Parameter			signal has been input.
m = F: OFF
	Alarm signal input is
	ignored.
M: ALARM/SENSOR
	Alarm recording or sensor
	recording is performed.
A: ALARM
	Alarm recording is
	performed.
S: SENSOR
	Sensor recording is
	performed.

76