Panasonic AG-DTL1 manual 100

RS-232C

$ Query control commands

Data transmitted by PC	Data returned from unit in response		Description of command
[STX] QUI [ETX]		[STX] LUISdata [ETX]	Queries the setting of the user ID to be recorded.
	Parameter
	data = U7U6U5U4U7U3U2U1U0
	Sets the user ID to be written using an
	ASCII code.
	Binary 4BITa8
	7
	ASCII code: 0—9, A—F
[STX] QVC [ETX]		[STX] VVCm:data [ETX]	Queries the results of detecting whether the video input
	Parameter		signals are present.
	m = A: Execution of detection		<Note>
		processing by VCC command	When the POWER switch is at OFF, the signals are not
		underway	detected, and an error results.
	S: Detection processing by VCC		Initiate the detection processing using the VVC command
		command completed or	before executing the QVC command.
		detection stopped	Correct results cannot be obtained unless processing has
	data = c13-16c9-12c5-8c1-4		been completed using the VVC command.
	c13-16= 1—F:
	Connection information for camera
	No.13—16
	c9-12= 1—F:
	Connection information for camera
	No.9—12
	c5-8 =	1—F:
	Connection information for camera
	No.5—8
	c1-4 =	1—F:
	Connection information for camera
	No.1—4
	<Note>
	For details on C¢, refer to the Camera
	connection information table.
[STX] QVM [ETX]		[STX] VMDm [ETX]	Queries the color setting for the video output signals.
	Parameter
	m = A: AUTO
		Color is switched automatically
		in accordance with the input
		signals.
	B: B/W
		Monochrome
[STX] QWB [ETX]		[STX] LWBm [ETX]	Queries the setting for whether the buzzer is to sound when
	Parameter		a problem occurs in the unit and the power is automatically
	m = N: Buzzer ON		turned off.
	F: Buzzer OFF
[STX] QXT [ETX]		[STX] LXTm [ETX]	Queries the setting for whether the signals from the external
	Parameter		timer connected to the rear panel terminal section are to be
	m = N: Signals are acknowledged.		acknowledged in the external timer recording mode.
	F: Signals are not acknowledged.

100