As shown below, firmly twist the end of the cord which is to be connected to the terminal section.
Firmly twist or solder here.
Solid wire : 0.4 to 1.2 mm diameter
Twisted wire : 0.3 to 1.25 mm
(The diameter of the strands must be 0.18 mm or more.)
When connecting or disconnecting the cord, press this part down using a regular screwdriver.
O Failure to twist the end of the cord firmly can cause
Alarm switch 1 | Alarm switch 2 |
When an alarm signal is input to | When an alarm signal is input to |
ALARM IN 1, alarm recording or | ALARM IN 2, alarm recording or |
sensor recording is performed. | sensor recording is performed. |
| External alarm lamp |
Alarm reset | External alarm buzzer |
| |
switch | External interface |
| |
+ |
|
– 4V to 5V |
|
1 | 2 GND | IN OUT | WARNING |
IN | RESET OUT | EXT | /REC OUT |
| ALARM | TIMER | TAPE END OUT |
| REC IN GND | TIME ADJ IN | |
O When alarm recording has been set for MODE on the menu screen shown on P4 ALARM/SENSOR REC, alarm recording is started when the alarm switch is set to ON.
O Alarm recording is released when the alarm reset switch is set to ON.
35