Setup Card Operations
Reading out data stored on cards
1 Set the MENU SET/OFF switch to SET. The page on which the previous setting menu opera- tions were completed appears on the viewfinder screen. (When the menu is used for the first time, the first page appears.)
2 Press the PAGE switch repeatedly until the SET UP CARD page shown below appears. (This operation can also be performed using the PAGE+UP/DOWN function.)
3
4
– SET UP CARD –
READ ( CAM)
WRITE ( CARD)
CARD CONFIG.
ID READ/WRITE :ON
FUNCTION1~2R/W:ON
L/M/H SET R/W :ON
LEVEL 1~6 R/W :ON
Press the SHIFT/ITEM button to move the cursor to the READ (
CAM) position.
Press the UP (or DOWN) button. When readout is complete, the message shown below ap- pears.
– SET UP CARD –
READ ( CAM)
WRITE ( CARD)
CARD CONFIG.
ID READ/WRITE :ON
FUNCTION1~2R/W:ON
L/M/H SET R/W :ON
LEVEL 1~6 R/W :ON
READ OK
5 When menu operations have been completed, set the MENU SET/OFF switch to OFF. The setting menu disappears from the viewfinder screen and the displays indicating the unit’s cur- rent status based on the data read out from the setup card appear at the top and bottom of the viewfinder screen.
When data is not read out
If the following error messages appear when the UP (or DOWN) button is pressed in step 4, the data is not read out.
Data readout error messages
Error message | Condition | Countermeasure |
NO CONFIG | The setup card is not | Format the card. |
| formatted. |
|
NO CARD | A setup card is not | Insert a card. |
|
|
ERROR | Data cannot be read out. |
Data written by devices other than this unit cannot be read out.
- 86 -
