Setup card operations, Formatting the setup card

Chapter 4 Adjustments and settings for recording

4-9-2 Setup card operations

To format the setup card, save the setting data on the card or read the saved data from the card, first perform a menu operation to open the <CARD READ/WRITE> screen from the FILE page.

#< CARD READ/WRITE >

R.SELECT :1

READ

W.SELECT :1

WRITE

CARD CONFIG

TITLE READ

TITLE:

1:******** 5: ********

2:******** 6: ********

3:******** 7: ********

4:******** 8: ********

Formatting the setup card

1 Perform the menu operations, and display the “CARD READ/WRITE” screen.

2 Turn the JOG dial button to move the arrow (cursor) to the CARD CONFIG item.

3 When the JOG dial button is pressed, the following message appears on the screen.

CONFIG?

YES

#NO

4 To proceed with the formatting of the setup card, turn the JOG dial button to move the arrow (cursor) to YES, and press the JOG dial button. When the formatting of the card is completed, the following message appears.

CONFIG OK

If one of the following messages appears when the JOG dial button is pressed, the card will not be formatted

Error message	Remedial action

CONFIG NG NO CARD	Insert the card.
(setup card has not been inserted)

CONFIG NG ERROR	The card may be defective.
(the card cannot be formatted)	Replace it.

CONFIG NG	Remove the card to cancel write
WRITE PROTECT	protect.

5 Press the MENU button to exit the menu operations.

The setting menu is cleared, and the displays showing the unit’s current statuses appear at the top and bottom of the viewfinder screen.

<Note>

Data titles cannot be recognized when the setup card was inserted while the CARD READ/WRITE screen was open. Move the arrow (cursor) to the TITLE READ item, and press the JOG dial button.

The data title is recognized, and the title is displayed.

Saving the data settings on the card