Panasonic AJ- E Setting the time data, Setting the user bits, CTL Vtcg Time Date P-iREC

Chapter 4 Adjustments and settings for recording

Audio level meter in display window

NDF SLAVE HOLD W						GPS		0		OVER
CTL VTCG TIME DATE P-iREC
								10
	h Y		minM	s D		frm
								20
TAPE
		E					B	30
BATT
		E					F	40
									OO
					1			-dB 2

Audio level meter display inside viewfinder

F:1----∫

R:2----∫---+

For the audio levels to be adjusted by one person only, it is recommended that the F.AUDIO LEVEL controls be used. Select in advance the audio channels whose levels are to be adjusted, and while monitoring the level meter on the viewfinder screen, adjust the F.AUDIO LEVEL controls in such a way that the input will not be too high.

1	Set the DISPLAY switch to UB.
2	Set the TCG switch to SET.
3	Set the user bits using the SHIFT button, UP (+) button
	and DOWN (–) button.
	SHIFT button:	This is used to cause the digit that is
		to be set to flash. Each time it is
			4
		pressed, the flashing digit moves to
		the right.
	UP (+) button:	This increments the numerical value
		of the flashing digit by 1.
	DOWN (–) button: This decrements the numerical value
		of the flashing digit by 1.
4	Set the TCG switch to F-RUN or R-RUN.
5	Open the <TC/UB> screen from the VTR MENU page
	and select USER as the UB MODE item setting by

performing menu operations.

4-5 Setting the time data

The time code setting range extends from 00:00:00:00 to 23:59:59:24.

4-5-1 Setting the user bits

Memos and other information with up to 8 digits (dates, times) in hexadecimal notation can be recorded on the sub code track by setting the user bits.

DISPLAY switch

Display window

TCG switch

DOWN (–) button

UP (+) button

HOLD switch

User bit memory function

The user bit settings (except for the actual time) are automatically saved in the memory and retained even after the power is turned off.

Tape continuity with the user bits

Selecting REGEN for the UB MODE item on the <TC/UB> screen by performing menu operations will call up the user bits recorded on the tape, making it possible to continue recording from that value. However, it is not possible to record the contents that were set.

<Note>

The time code/user bits are also recorded in the VIDEO AUX area of the unit’s memory. The time code (VITC) is the same value as the sub code area’s time code (LTC).

Special information such as the camera’s frame rate is recorded in the user bits (VITC’s user bits).

VITC’s user bits

¢¢:0F:50:0¢

			Tape management information
	Fixed value		≥Renew frame flag
			≥REC START/STOP mark
Checking information
for the 6 digits at right.
			Camera shooting mode
		500:		50i

33