Basic operations
Inserting P2 card
When inserting a P2 card into the P2 card slot of the P2 drive provided in the unit, be absolutely sure to position the P2 card parallel to the slot and insert it straight into the drive.
•Forcing cards in the slot at an angle may damage P2 card, P2 Drive or this unit.
•To prevent cards from falling out, protect the unit from dust, and reduce the risk of exposure to static electricity, remove P2 cards before moving the unit.
•Format P2 cards only on a P2 card device.
1 Turn the unit on.
2
When a P2 card is inserted, an icon is displayed on the control panel.
Also at this time, the P2 CARD ACCESS LED for the corresponding slot indicates the status of the P2 card.
|
| Insert the card with the | |
|
| logo facing up. | |
P2 CARD |
|
| |
ACCESS |
| Status of P2 Card | |
LED |
|
| |
Blinks in | Being | Reading is being performed. | |
green | accessed | ||
| |||
Quickly | Being | The P2 card is being | |
blinks in | |||
recognized | recognized. | ||
green | |||
|
| ||
| Card not | The card is not supported by | |
| supported | the unit. Use another card. | |
Stays off | Incorrect | The P2 card is not properly | |
format | formatted. Reformat the card. | ||
| |||
| Card not | No P2 card is inserted. | |
| inserted | Card recognition standby. |
Ejecting P2 card
1 Press the EJECT button next to the P2 card slot.
2 After the EJECT button emerges, press it again to eject the P2 card.
•During access or detection of P2 cards after insertion (when the P2 CARD ACCESS LED blinks in green), do not remove the cards. Removing cards during
access may damage them. |
|
• If a P2 card being formatted is removed, it may not |
|
be formatted properly. |
|
• Do not move the unit while the EJECT button is set | EJECT button |
to its out position. Doing so may cause damage. Be |
|
sure to press the EJECT button and set it to its in |
|
position first. |
|
To Prevent Accidental Erasure of P2 Card Content
To prevent the content of a P2 card being accidentally erased, position the
14