Control reference guide (continued)

Back Panel

1GBASE-TX

12

LAN

F

DC IN

POWER

ON

OFF

A

B

C D E

A Battery holder

 

F LAN connector

You can install the battery directly if it is compatible with Anton Bauer battery holders.

•Charge the battery with the battery charger before using it. (For details on the charging methods, refer to the operating instructions concerned.)

•When replacing the battery plate or installing the V-mount type adapter plate, consult your dealer.

•When installing the battery plate, take care not to sandwich or pinch the connecting wires.

BCooling fan

CDC-IN connector

This DC-IN connector (XLR 4 pin) is used with an external DC power supply.

Use an external DC power supply with a rated value of 100 W or more.

DRear POWER switch

Use this switch to turn the power ON or OFF when an external DC power supply or battery is used. •When the switch is ON, the power (about 2W) is still consumed in idle state. Always turn the power OFF when the unit is not used.

•If the switch is set to OFF during HDD operations, it may cause HDD failure. Set the switch OFF after normal shutdown.

ERear POWER LED

Lights when the rear POWER switch is ON.

These LAN connectors support speeds of 1000, 100 and 10 Mbps.

Please set the IP address in GUI of this unit. (page 38)

●Use of external DC power supply

Make sure that the output voltage of the external DC power supply meets the rated voltage of the unit before connecting the power supply.

Inrush current occurs when the unit is turned on, and insufficient power at this time may damage the unit. Thus, we recommend using an external DC power supply rated at least 100 W. Use the DC cable recommended for the external DC power supply.

•When using an external power supply other than the AC adapter, check the DC IN socket pin information to ensure correct polarity. If a +12 V power supply is accidentally connected to the GND terminal, this could cause a fire or personal injury.

DC IN

Pin No.

Signal

 

 

1

GND

2

4

2, 3

-

3

1

 

 

 

 

 

4

+12 V

•When both the battery and the external DC power supply are connected, power is supplied from the external DC power supply. The battery can be removed or mounted while using an external DC power supply.

•When using an external DC power supply, make sure you turn on the external DC power supply before turning on the unit’s power switch.

7