Setting the RAID function (continued)
RAID Settings
The basic processing of the RAID1 function is set.
A
B
C
D
E
ARebuild Rate
BAutomatic Rebuilding Status
●Enable button Rebuild automatically.
●Disable button Rebuild manually.
To initiate rebuilding, press the START button of the Rebuild tab.
CBuzzer Status
These control the ON/OFF statuses of the BUZZER on the RAID board. This BUZZER sounds when trouble has occurred on the RAID button.
Set the rebuilding rate.
While the rebuilding process is underway, both playback and access from an external source via the LAN can be performed at the same time. When rebuilding and playback or rebuilding and external access have been performed at the same time, the rate of not only the rebuilding but the playback or external access as well will be reduced.
For details on the rates provided by the LOW button, MEDIUM button and HIGH button, refer to the table below.
| LOW | MEDIUM | HIGH |
| button | button | button |
Rebuilding time | Slow | Normal* | Fast |
Playback frame | Low | Middling | High |
number of | number of | number of | |
skip amount | frames | frames | frames |
|
*The rebuilding time is about 2 hours for 500 GB. The rebuilding times given are estimates only and will vary depending on the HDD used and operating environment.
●Enable button
Buzz when HDD is plugged.
●Disable button
Be quiet all the time.
DAPPLY button
Register currently set details.
ECLOSE button
Return to the main screen.
21