Control reference guide

Front Panel

HDD1

A

B

HDD2

HEADPHONES

C

D

E

F

G

H I J K

AFront POWER LED

Lights when the unit is ON.

When the LED goes off and the rear POWER switch is ON, electric power is still consumed. Always turn the rear POWER switch OFF when the battery is not used.

When an external DC power supply is used, standby power will continue to be consumed so set the rear POWER switch to OFF.

BFront POWER button

This button is used to start up the unit and shut it down.

When it is at the OFF setting:

The unit starts up when the front POWER button is pressed.

When it is at the ON setting:

The unit shuts down automatically when the front POWER button is pressed. After the unit has shut down, set the rear POWER switch to OFF.

CGrips

This is the handle for carrying the unit.

DHEADPHONES jack

Use mini-jack HEADPHONE.

ELCD panel with touch panel

All the operations are done on the touch panel except power ON and OFF.

F5-inch bay units used to install the HDD You can install the HDD (SATA) which you purchased with the 5 inch bay unit.

For details on the installation method and the HDDs which can be used, refer to the procedure described separately, and proceed with the installation. (page 9)

GP2 Drive

The P2 drive has been installed.

HPower Indicator

This indicator lights up in green when the P2 drive is running.

IStatus Indicator

This indicator blinks in green during access to a P2 card.

Do not remove the P2 card during access of the card, otherwise files may be corrupted, or the P2 card may fail.

JCard Slots

The P2 drive’s card slots are designed for P2 cards. The P2 drive does not operate with cards other than P2 cards.

KEJECT Button

To remove a P2 card, press this button so that the button pops out, then press it in again.

6