Copying (continued)
Manual copy mode (continued)
Take the steps below for manual copying.
1 In SOURCE, select the P2 card to copy. (More than one card can be selected using SLOT1 to SLOT5.)
2 In DESTINATION, select the destination for copying.
(HDD1, HDD2 for the JBOD mode; no destination selected for the RAID1 mode)
Auto copy mode
In auto copy mode, a popup screen is displayed when a P2 card is inserted.
A B C
3 Press the START button.
Copying will begin.
A confirmation screen will be displayed for any cards that have already been copied.
Press the YES button to proceed to a screen displaying the current copying progress (page 24). Press the NO button to return to the main screen.
ACopy All button
Copy the currently inserted card.
BCopy New button Copy new cards only.
CCancel button
Return to the main screen without automatic copying.
If you press CLOSE button in this screen, you will go back to the main screen.
In RAID1 mode, there is only one destination available, and there is no need to select it in step 2.
In this mode, the unit detects when a card is inserted. If no other card is inserted within 10 seconds, data is automatically copied from the inserted card to the designated HDD.
After copying, it will copy automatically when inserting a new P2 card.
•Multiple P2 cards may not be recognized if inserted at the same time. In this case, automatic copying is not performed.
Try reinserting the P2 cards.
•Auto copy will not be executed even when the unit is started or restarted while a P2 is inserted.
•The data is not copied automatically if the amount of recordable memory on the HDD is less than that on the P2 card.
•If a copied card has been inserted into the HDD while ON is set for the copied card check function (Card Check), auto copy will not be executed.
To
23