5-1-2 Using an AC Power Supply

When using the Panasonic AJ-B75 AC adapter

1Plug the AJ-B75 DC OUT connector into the camera- recorder’s external DC input socket.

DC IN Socket

AC Adapter

zAJ-B75 (Optional)

2Turn the AC adapter power ON.

3Turn the camera-recorder power switch ON.

5-2

Mounting the Viewfinder and

 

 

Adjusting its Position

 

Please refer to the viewfinder instruction manual.

 

Note: A slide rail is required to mount any viewfinder other than

 

models AJ-VF15B or AJ-VF20WB.

 

z If you need to buy a slide rail, please contact the store where

 

you purchased the camera-recorder and tell them that the

 

slide rail is a “repair part”.

 

Slide rail (VFC3995)

 

Screws (XBS3+8VZ)

 

Mounting the Slide Rail

 

1 Undo the upper two screws for AJ-VF15 or AJ-VF20W, and

5

remove the mounting unit.

Leave the screws attached to the mounting unit.

Mounting unit

Screws

When using an external power supply other than the AC adapter AJ-B75, check the DC IN socket pin information to ensure correct polarity. If a +12V power supply is accidentally

connected to the GND terminal, this could cause a fire or 2 Mount the slide rail, then tighten the two screws. personal injury.

Slide rail

4

Pin No.

Signal

3

1

GND

2

2, 3

—

4

+12V

1

DC IN Socket

<Notes>

z When both the battery pack and AC adapter are connected, power is supplied from the AC adapter. The battery can be removed or mounted while using the AC adapter.

z When using the AC adapter, make sure you turn ON the AC adapter power before turning ON the camera- recorder’s power switch. If this sequence is reversed, the camera-recorder may malfunction due to slow rising of the AC adapter output voltage.

z When connecting a battery to the DC IN socket, select the battery type listed under EXT DC IN SELECT. Select EXT DC IN SELECT from the <BATTERY/P2CARD> screen on the MAIN OPERATION page. In this case, however, the % display is disabled, even when using a digital battery.

67